![]() Select the user associated with the keychain remote and toggle on the 'Access to Panic Mode.' Once panic is enabled on the keychain remote, it can be initiated on the keychain remote by pressing 'Stay. Each input will require its own wireless zone when doing this. To enable the ability to set off a panic alarm from the keychain remote, go to Menu > Users > Select. This can be useful if a user ever runs out of key fob zones. While it is normally recommended that a key fob is enrolled using one of the system's key fob zones, it is also possible to enroll a key fob input as a standard wireless zone. This gives both of these key fobs a maximum of eight configurable inputs. Both the Honeywell 5834-4 and the Honeywell SiXFOB can support four dual-button inputs. These inputs will also need to be programmed with the system, just like any single-button press. A dual-button press means pressing and holding two buttons on the device at the same time. This is done from the Automations Menu.Īdditionally, many four button key fobs can actually be used for additional commands through dual-button presses. The user can then set an automation to take effect whenever that zone is faulted. This will have the panel still recognize that the key fob zone was faulted, but it will not take any action. KEYPAD: Press the star () and pound () buttons at the same time. To trigger the panic button: TOUCHPAD: Tap the orange button, then select the emergency. If a user wants an input to perform an automation, such as activating a smart scene, then they should set the input to "No Response". The panic button can only be selected when you are at home. This button is not set to anything by default, but it is commonly programmed to trigger a panic or an. The lower-right button (D) is a red star. This button is normally used for Arming Stay. The lower-left button (C) is a person standing inside a house. This button is normally used for disarming. ![]() Commands for arming, disarming and triggering alarms are found normally within key fob zones. The upper-right button (B) is an open lock. This button is not set to anything by default, but it is commonly programmed to trigger a panic or an automation.Įven though these are the recommended functions, a user can technically set a key fob input to perform any command of their choosing. Step 3 Separate the rubber buttons from the circuit board. This button is normally used for disarming. Use a screwdriver or a coin to pry apart the two halves of the key fob cover. The upper-right button (B) is an open lock. This button is normally used for Arming Away. The upper-left button (A) is a closed lock. Most Honeywell Key Fobs have four buttons arranged in a similar pattern. ![]() However, each key fob button input can technically be programmed however the user would like. If the device is programmed with the recommended settings, then the pictures will help the user identify each button's purpose. Each button has a specific meaning on a Honeywell Alarm Key Fob. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |